Silo Design Calculation Using FEA (Solidworks Simulation)

The software used for this FEA analysis is Solidworks Simulation Premium.

The rules and regulations of the following authority have been used in this mechanical design adequacy.

NA to SS EN1991-4: 2010(2015) Part 4: Silo and Tanks,

BS EN 1991-4 Eurocode 1 - Actions on structures - Part 4: Silos and tanks

BS EN 1993-4-1 - Design of Steel Structures —Part 4-1: Silos

BS EN 1993-1-6:2007 — Design of steel structures-Part 1-6: Strength and Stability of Shell Structures





























Comments

Post a Comment

Popular posts from this blog

FRP DUCTING DESIGN FEA SUMILATION

Image
1.1 Introduction  This report aims to check the design adequacy of the modified rectangular header and branch duct branch.    This analysis is carried out with Finite Element analysis using Solidworks simulation static structure composite analysis.    The design of the ducts is based on the requirements of SMACNA.  Construction of the FRP ducts is by filament winding for the circular ducts and by hand lamination for the rectangular ducts. The material's properties have been taken from Win Fung Test figures for this construction.  For conservatism, a small reduction in properties have been assumed.  The corrosion barrier has been included in the structural calculations as per SMACNA as the environmental conditions are not severe. The corrosion barrier V,2M, is approx. 2.5mm thick.  1.2 Code & Reference Documents  a. Thermoset FRP Duct Construction Manual SMACNA  b. ASME RTP-1  c. PUB/WRP/CWRP-2/MXXX  d. P2E-CWRP-HSL-20-WF-D-001 $ 003  1.3 Design Parameters  Design Temperature Am
Read more